3 ways controlling the temperatures of injection mold
A temperature indicator, normally a thermocouple,calculates the temperature of the heaters or the hot runner channel. The positioning of the thermocouple is important for genuine control of the melt Plastic. Precise control is crucial for heat-sensitive materials and generally, the sensing unit is found midway between the heater and the melt channel.
Using smaller unit inside hot nozzles ,it is difficult to place them in this location and they also need to be put within the heaters itself. To make up for this, it will be important to set the temperature 20-30 C higher than the melt temperatures for that substance. That takes account of the thermal gradient which is available between the heater and material in the melt channel.
By using closed-loop techniques, the sensing unit transfers back information towards the temperature controller, which often either adjusts or changes current to help keep pre-programmed conditions. Closed- loop systems are essential for processing heat-sensitive materials, as precise temps control over the melt is crucial for these.
The temps controllers can be predictive where they continuously regulate the temperature rather than simply switching don / doff, as is the case with the less difficult, cheaper reactive forms.
Open-loop manage is used in tools in which accurate control of the melt temperature is never critical. Thermocouples are certainly not used and hence there isn’t any control on temperature.
In these situations, temperatures inside the manifold are established simply by experimentation. If the suitable conditions have been identified, then, the reliable manufacturing may be accomplished with straightforward non-heat-sensitive materials.
Open-loop management devices mustn’t be used for heat-sensitive materials or for complicated usage in which melt temperature could be essential.
As said before , the great heat transfer is really important for reliable manufacturing and superior work surface contact is required between heating elements and the surfaces they arc heating up.
Rapid breakdown of heaters also occurs by switching them on to full power when the manifold is cold. To prevent this,a soft start facility on the temp operator is suggested. This system gives a low-power commence to the heaters through supplying a reduced voltage or temp for the earliest 15-20 minutes following the heating units have already been switched on.
Link to this article：3 ways controlling the temperatures of injection mold
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.：Silicone And Casting，Thanks